Hello,
Thanks for releasing this project. I am looking at the v2 ANSI plate and the dimensions of the switch cutouts are roughly 18.5mm x 18.5mm. I believe that's the size of keycaps, while the switch cut outs should be roughly 14mm x 14mm. Am I reading these dimensions correctly? If so, the plate will not hold switches.
Thanks,
Jared
Hello,
Thanks for releasing this project. I am looking at the v2 ANSI plate and the dimensions of the switch cutouts are roughly 18.5mm x 18.5mm. I believe that's the size of keycaps, while the switch cut outs should be roughly 14mm x 14mm. Am I reading these dimensions correctly? If so, the plate will not hold switches.
Thanks,
Jared