Welcome to Flyfisher604/mpcnc_posts_processor Discussions! #1
Replies: 5 comments 13 replies
-
|
Hi! |
Beta Was this translation helpful? Give feedback.
-
|
Dear, Thanks for the post possessor, looks very promising. https://docs.duet3d.com/User_manual/Reference/Gcodes#m452-select-laser-device-mode I'd love to hear your opinion |
Beta Was this translation helpful? Give feedback.
-
|
First off thank you for putting in the hard work to make this. |
Beta Was this translation helpful? Give feedback.
-
|
Getting back into my MPCNC with Fusion, and saw Fusion made a few changes. Was A Guffy PP user in the past, and found yours as first in my search for a current one. Looks great! Did you have support for Router'Laser ON/OFF commands for Marlin? I had been using M106/M107 Fan PWM's for this on my build. Router: M106 P0 = ON, M107 P0 = OFF |
Beta Was this translation helpful? Give feedback.
-
|
Absolutely loving the post processor for Klipper! Question for you though, is there any way to get Estimated Time to Completion out of Fusion into Klipper? Thanks! |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
-
👋 Welcome!
We’re using Discussions as a place to connect with other members of our community. We hope that you:
build together 💪.
To get started, comment below with an introduction of yourself and tell us about what you do with this community.
Beta Was this translation helpful? Give feedback.
All reactions