Hello Mr.Pavel, thank you for your amazing work!
My name is Wolf, a website programmer from China, recently I want to make a printing and cutting machine, but I don't have any hardware experience before, so I start learing everything from the beginning. so far I know how to write a app to send command to esp32 and I almost solving the cutting part with grbl. However, I have no idea how to solve the printing part, then I found the magicbrush and your Print Spider project(Apparently your project is much smaller and neater, so I want to try this solution). I saw that you said this project was uncompleted on hackday, so I wonder that have you finished the final part yet? Is there any advice you may share with me?
Thank you for your contribution again! Looking forward to your reply!
Hello Mr.Pavel, thank you for your amazing work!
My name is Wolf, a website programmer from China, recently I want to make a printing and cutting machine, but I don't have any hardware experience before, so I start learing everything from the beginning. so far I know how to write a app to send command to esp32 and I almost solving the cutting part with grbl. However, I have no idea how to solve the printing part, then I found the magicbrush and your Print Spider project(Apparently your project is much smaller and neater, so I want to try this solution). I saw that you said this project was uncompleted on hackday, so I wonder that have you finished the final part yet? Is there any advice you may share with me?
Thank you for your contribution again! Looking forward to your reply!