You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hello, I noticed that the 120ohm CAN termination resistor is present on the node. As far as I know this would violate the bus spec if a few such nodes are connected on the same bus. Wouldn't it be better to leave these unpopulated?
Hello, I noticed that the 120ohm CAN termination resistor is present on the node. As far as I know this would violate the bus spec if a few such nodes are connected on the same bus. Wouldn't it be better to leave these unpopulated?