Example08_DistanceSerialPlotter.ino

/*
  Example 8: Distance Serial Plotter

  Using the Acconeer XM125 A121 60GHz Pulsed Coherent Radar Sensor.

  This example prints out the distance values of the 0 distance
  channels to the serial plotter tool in Arduino.

  By: Madison Chodikov
  SparkFun Electronics
  Date: 2024/1/22
  SparkFun code, firmware, and software is released under the MIT License.
    Please see LICENSE.md for further details.

  Hardware Connections:
  QWIIC --> QWIIC

  Serial.print it out at 115200 baud to serial monitor.

  Feel like supporting our work? Buy a board from SparkFun!
  https://www.sparkfun.com/products/ - Qwiic XM125 Breakout
*/
#include "SparkFun_Qwiic_XM125_Arduino_Library.h"
#include <Arduino.h>

SparkFunXM125Distance radarSensor;

// I2C default address
uint8_t i2cAddress = SFE_XM125_I2C_ADDRESS;

// Error statuses
uint32_t distanceSetupError = 0;

// Distance Variables
uint32_t distancePeak0 = 0;

void setup()
{
    // Start serial
    Serial.begin(115200);
    Serial.println("XM125 Example 8: Distance Serial Plotter");
    Serial.println("");

    Wire.begin();

    // If begin is successful (0), then start example
    if (radarSensor.begin(i2cAddress, Wire) == 1)
    {
        Serial.println("Begin");
    }
    else // Otherwise, infinite loop
    {
        Serial.println("Device failed to setup - Freezing code.");
        while (1)
            ; // Runs forever
    }

    int32_t setupError = radarSensor.distanceSetup();
    if (setupError != 0)
    {
        Serial.print("Distance Detection Start Setup Error: ");
        Serial.println(setupError);
    }

    // New-line and 0.5 second delay for easier reading
    Serial.println();
    delay(500);
}

void loop()
{
    distanceSetupError = radarSensor.detectorReadingSetup();
    if (distanceSetupError != 0)
    {
        Serial.print("Distance Reading Setup Error: ");
        Serial.println(distanceSetupError);
    }

    // Read PeakX Distance and PeakX Strength registers for the number of distances detected
    radarSensor.getPeak0Distance(distancePeak0);

    // If a peak distance was detected, then read out the distance and strength
    if (distancePeak0 != 0)
    {
        Serial.println(distancePeak0);
    }

    // Half a second delay for easier readings
    delay(500);
}