Assembly
Snapping the compression latches can be done with two bolts like shown in the video below:
Compression.Latch.Snapping.mov
The access latch has a space intended for one heat insert so that a bolt can be used to unclip it from the outside, to access the electronics inside.
The flow chamber access latch is designed to snugly fit the Mateksys buck converter.
Both BME and SGP sensors share the same I2C bus, so they can be soldered stacked onto each other. The full assembly in their holder should look like so:
Note: This is not they fit in StealthMax S version. Don't solder them onto each other if you are building a StealthMax S.
| Soldering | Mounting onto holder |
|---|---|
 |
 |
