Important
main documents the current live Klippventurer setup: a v0.2.x manual/soldered host install workflow (ongoing state, not a tagged release line).
Looking for the next-generation stock-like USB installer work? See the preview USB Install Branch: next/firmware-package.
| Printer | Printing | Easy Installer | Pin table | Printer.cfg | Thermistor Calibration | Display | Touch | Filament Runout | Camera |
|---|---|---|---|---|---|---|---|---|---|
| Adventurer 3/Pro* | ✅ | ⏰ | ✅ | ✅ | ⏰ | ⏰ | ⏰ | ⏰ | ⏰ |
| Adventurer 3 Pro 2 | ❓ | ⏰ | ❓ | ❓ | ⏰ | ||||
| Adventurer 4 | ⏰ | ⏰ | |||||||
| Adventurer 5M/Pro | ✅ | ✅ | ✅ | ✅ | ✅ | ✅ | ✅ | ✅ | |
| Creator Pro 2 | ❓ | ❌ | ❌ | ||||||
| Creator 3/Pro | ⏰ | ❌ | ❌ |
✅Working ⠀⠀ ⏰In Progress ⠀⠀
Note
"Adventurer 3" Includes the Adventurer 3C, Lite, and Pro, as well as rebrands such as the Bresser Rex, Arçelik PT1000, MonoPrice Voxel, and potentially other printers based on the SZ16 mainboard.
For installation instructions, please see the docs
Warning
Always calibrate your Z offset and mesh bed leveling after installing Klipper!
This repo, supported features, and guides change often, join our Discord or watch the repo for updates. Please open an issue or pull request if you encounter any problems with installation.
- Nation N32G MCU doesn't work with current .config
- Can't currently support screen, buzzer, USB, filament runout sensor, or camera. Support for these is planned as part of future USB installer work.
- Adventurer 3 Pro works, but you need to modify printer.cfg to use TMC2209 drivers instead of TMC2208.
@hw-lunemann for fixing UART muxing and tuning input shaper on Adventurer 3
@kyleisah and everyone who contributed to KAMP
@KevinOConnor and everyone who contributed to Klipper
@FlashforgeOfficial for good hardware at a fair price
