Tallac RestConf

To use your Tallac AP with the SDN Developer Lab's RestConf API you need to set the SDN Developer Lab's controller as the OpenFlow controller for your Tallac AP.

Connect SDN Developer Lab Controller as the OpenFlow controller for Tallac AP.

1. In Tallac's cloud management GUI select the Site that you want to connect.
2. In the Tallac's cloud management GUI on the left side, select 'Configuration', then select 'OpenFlow Settings', then select 'Edit'.
   1. In the 'OpenFlow Settings' configure the following information to connect it with SDN Developer Portal:
      1. OpenFlow Controller: IP address of your SDN Developer Portal Controller (Found in the header of the SDN Controller table in SDN Developer Lab )
      2. Port: OpenFlow port of your SDN Developer Portal (Found in the header of the SDN Controller table in SDN Developer Lab )
      3. Use a Secure Connection: DISABLE (uncheck)
   2. Select 'Save'.
3. The Tallac AP is now configured to use your SDN Developer Lab's OpenFlow controller and the RESTCONF API is active.